The build starts with the Building board. Bild entfernt (keine Rechte) I have also tried to replicate how the mast and boom are builtup. Here are the two first trials. Bild entfernt (keine Rechte) Bild entfernt (keine Rechte) Mast Bild entfernt (keine Rechte) Bild entfernt (keine Rechte) Boom
are those frames controlled with the lines? Is everything in a perfect harmony?
Then it's ok to make such thin frames. If not, please make them a bit wider. At least 10 mm at a boat of this size. I recommend 9 mm Multiplex Birch plywood. Don't forget the cutouts for the strips at the corner of Deck and hull and at the corner of Deck and cabin/cockpit. Also deduct the material for planks and Deck. Should be about 2,5 mm or 3,5 if You take 4 mm planks.
If You are not working with perfect controlled lines, please make the frames 15 mm wide. So there is a bit more material to straighten the framework. The weigh of this wood shouldn't be a problem.
By the way, the feets of the frames shold be bigger, that fixes the better on the building board.
The attached file shows an example for my way to design frames.
Bild entfernt (keine Rechte)
And please set every 100 mm a frame. That's a good distance for the planks.
Best Regards
Lothar
Lothar
hat folgende Bilder an diesen Beitrag angehängt
are those frames controlled with the lines? Is everything in a perfect harmony?
Yes as good as i can do it.
Then it's ok to make such thin frames. If not, please make them a bit wider. At least 10 mm at a boat of this size. I recommend 9 mm Multiplex Birch plywood. Don't forget the cutouts for the strips at the corner of Deck and hull and at the corner of Deck and cabin/cockpit. Also deduct the material for planks and Deck. Should be about 2,5 mm or 3,5 if You take 4 mm planks.
I have deducted 3mm for planks and deck, i was planning to use 4mm plywood as frames, they are 10mm wide. Cutouts will be made with my bandsaw, as is finnishing of the frames. These will only be papertemplates to cut out the frames and keel
If You are not working with perfect controlled lines, please make the frames 15 mm wide. So there is a bit more material to straighten the framework. The weigh of this wood shouldn't be a problem.
By the way, the feets of the frames shold be bigger, that fixes the better on the building board.
Good, i will alter them.
The attached file shows an example for my way to design frames.
And please set every 100 mm a frame. That's a good distance for the planks.
Yes i know i have made frames with oddnumbers now i will have to make the ones with even numbers.
Well, If you didn't buy plywood yet, please look out for 9 mm multiplex brich plywood. Herr you can get it in Bauhaus. May be You take a look at biltema?
Bild entfernt (keine Rechte) So i start with spant and sideview in the right scale and squared.(Since the scan wasn't square) Get a couple of guidelines done and the keel.
Klassik-Modellyachten
Thema drucken
22.12.2021 12:59 (zuletzt bearbeitet: 22.12.2021 13:07)
Antworten
